Minelab Excalibur II Instruction Manual download pdf (Page 11)

Instruction Manual Page 11

d) Push the black nylon bolt (11) through the holes in the bracket on the coil

from the cable entry side, then place the wing-nut on the other end of the

bolt and tighten it by hand.

Figure 4 - Excalibur with shaft assembled for Diver’s Mode

Completing the Shaft Assembly

a) Slide the lower shaft assembly into the upper metal shaft. Note that the

black plastic twistlock nut (14) may need to be loosened to get the lower

shaft assembly in place.

b) Begin winding the coil cable firmly around the shaft by rotating the lower

black stem. Wind between 25 and 28 turns of the cable until it reaches the

control cylinder.

c) Set the length of the shaft by locking the spring clip into one of the 3 holes

provided, and then tighten the plastic locking ring by hand.

NOTE:

Leave enough slack at the bottom of the cable near the coil to adjust the

coil position without straining the coil cable.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 28 29

No comments

Minelab Excalibur II Instruction Manual Page 11