Minelab GPX-4000 Service Manual download pdf (Page 7)

8 9

Attaching the Coil to the Lower Shaft:

1 Plug the two rubber washers into the holes on

either side of the lower shaft.

2 Ensure that the spring loaded pin of the lower

shaft is pointing downwards. Slide the lower shaft

into the bracket on top of the coil.

3 Insert the bolt through the lower shaft and the

bracket on top of the coil. Fasten with the nut

provided, being careful not to damage the thread

of the nut by over-tightening. This may need to

be loosened to adjust the coil to a comfortable

detecting angle.

The coil cable is directly wired into the coil and is not

removable. Any attempt to disconnect this cable will

void your warranty.

If the coil becomes loose over time, the rubber

washers may need to be replaced.

Assembly

Attaching the Lower Shaft to the Upper Shaft:

1 Rotate the twistlock of the upper shaft counter-

clockwise to ensure that it is loosened.

2 Compress the spring loaded pin of the lower shaft.

Slide the lower shaft into the upper shaft until

the pin reaches an adjustment hole. The pin will

spring out and clip into place.

Attaching the Handle to the Upper Shaft:

1 Slide the bungy cord clamp onto the upper shaft.

2 Slide the handle onto the upper shaft so that it

slopes away from you.

Attaching the Armrest to the Upper Shaft:

1 Place the two armrest halves on either side of the

upper shaft, aligning the armrest and upper shaft

holes.

2 Insert the bolts through the armrest and upper

shaft holes.

3 Loosely fasten the wing-nuts onto the bolts (these

will be tightened after the control box is attached).

spring loaded pin

1 2 3 4 5 6 7 8 9 10 11 12 ... 46 47

No comments

Minelab GPX-4000 Service Manual Page 7