Minelab GPX-4000 Service Manual download pdf (Page 8)

10 11Assembly

Connecting the Coil Cable:

1 Wind the coil cable around the lower and upper

shafts enough times to take up the slack. Leave

enough slack at the bottom of the cable near the

coil to allow the angle of the coil to be adjusted

while detecting.

2 Use the Velcro straps to keep the coil cable in

place against the shaft.

3 Plug the coil connector into the coil socket on the

control box, firmly tightening the retaining ring to

hold it in place.

Attaching the Armrest Strap to the Armrest:

1 Press both strap studs onto the armrest studs.

2 Push the armrest straps through the slots in the

armrest cover and then push the cover over the

armrest.

Connecting the Control Box to the Upper Shaft:

1 Place the detector on a flat surface, with the

handle facing upwards.

2 Position the armrest on top of the control box.

3 Clip the control box onto the armrest, ensuring

that the battery plug faces the rear.

4 Fasten with the wing-nuts.

5 Wind the Quick-Trak button cable around the

upper shaft and plug it into the Smart Point

socket in the control box. Ensure that the cable is

wrapped firmly, but avoid strain on the connector.

If the Quick-Trak cable

becomes loose, try securing

it onto the shaft with

electrical tape.

Always ensure that the control box is turned

off before connecting or disconnecting the coil

to avoid damage to the detector's electronics.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 46 47

No comments

Minelab GPX-4000 Service Manual Page 8