Minelab X-Terra 705 Instruction Manual download pdf (Page 4)

Connecting the Coil

Plug the two rubber washers into the holes

on either side of the lower shaft yoke.

Slide the yoke into the yoke bracket on top

of the coil. Ensure that the spring loaded pin

in the lower shaft is pointing downwards.

Insert the plastic bolt through the yoke

and the yoke bracket.

Fasten with the plastic wing nut provided,

being careful not to damage the thread

of the bolt by over-tightening. This may

need to be loosened to adjust the coil to a

comfortable detecting angle.

The coil cable is directly wired into the

coil and is not removable.

Any attempt to disconnect this cable

will void your warranty.

Shaft Assembly

Ensure that the twistlocks of the shafts

are loosened by rotating them counter-

clockwise.

Compress the spring loaded pin in the lower

shaft and slide it into the middle shaft until

the pin reaches the adjustment holes. The

pin will spring out and click into place.

Attach the middle shaft to the upper

shaft in the same way.

Once shafts are assembled, lock them in

position by rotating twistlocks clockwise.

The upper shaft assembly location

uses two spring loaded pins to

strengthen the joint, one on each side

of the shaft.

List of Parts

Before assembling your X-Terra 705 please

check that the package includes these parts:

Coil

Skidplate (tted to coil)

Lower shaft

Middle shaft

Upper shaft

Armrest

Stand

Control box

Control box screw

Rubber washers (2)

Plastic wing nut

Plastic bolt

Armrest screw

Armrest strap

Velcro tabs (2)

Warranty card

Instruction manual you’re holding it

:-)

54

assembling your x-terra 705

1 2 3 4 5 6 7 8 9 ... 30 31

Comments to this Manuals

No comments