Minelab F3 Service Manual download pdf (Page 32)

F3 Field Service Manual

Page 32

c. To refit the armstrap use Figure 43 as a guide:

Figure 43: Lacing the Armstrap (View from Coil)

3.9 Shafts. The following procedures detail shaft disassembly/assembly and should be

followed in order until the component to be replaced is accessible. Figure 44 illustrates the

components of the shaft assembly.

er Camlock Assembl

Middle Camlock Assembl

er Shaft

Yoke and Lower

Camlock Assembly

Figure 44: Shaft Assembly Components

a. To disassemble lower camlock and lower shaft:

● Remove the electronics pack (Section 3.3.a) and coil (Section 3.4.a)

● Using Figure 45 as a guide, use the 3mm T handle hex driver from the Tool Kit to

push out the two lower camlock pins (Part 5).

● Remove the lower camlock body (Part 1) from the lower shaft.

● Remove the lower shaft by pushing it back through the upper/middle shafts.

Lower Shaft

Middle Shaft

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 41 42

No comments

Minelab F3 Service Manual Page 32