Minelab EXPLORER II Service Manual download pdf (Page 38)

THE MINELAB EXPLORER II

CONTROL PANEL

www.minelab.com

Iron Mask

Figure 4.7

The IRON MASK shortcut button allows you to quickly switch

between two detection modes: Discrim and Iron Mask.

Assuming the detector is in the preset Discrim Coins function:

• Pressing the button once switches to the adjustment screen

for Iron Mask which allows you to set the detector’s level of

ferrous rejection.

• Pressing the button a second time switches to the Iron Mask

function.

• Pressing the button again returns you to Discrim Coins.

Discrim displays a pattern representing which targets are

selected from the Discrim Select list (the factory preset is Coins).

This pattern is explained in detail on page 42 of Chapter 5:

Quickstart. A small bar also appears at the bottom of the

Smartfind screen to indicate whether Iron Mask is ON or OFF.

Pinpoint

Figure 4.8

The Explorer II is programmed to operate as a motion detector

(detecting targets as the search coil is swept). The PINPOINT

shortcut button overrides this automatic setting enabling the

Explorer II to become a non-motion detector. This allows a

target’s location to be pinpointed. Continuous target response will

be emitted when the search coil is positioned directly over a

target.

A small bar appears at the bottom of the screen to indicate

whether Pinpoint is ON or OFF. It will flash in ON mode to remind

you to turn Pinpoint OFF. Using the Pinpoint function is explained

in detail in Chapter 5: Quickstart (page 59-60).

SHORTCUT BUTTONS

Figure 4.7 Iron Mask shortcut button

Figure 4.8 Pinpoint shortcut button

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 111 112

No comments

Minelab EXPLORER II Service Manual Page 38