Minelab EXPLORER II Service Manual download pdf (Page 77)

THE MINELAB EXPLORER II

ADVANCED USE

Figure 6.2 Advanced Mode’s Learn display

Figure 6.3 Accept all clears the screen

This tutorial shows you how to learn a target, make

adjustments and save your selection.

Phase 1: Preparation for Learn

STEP 1 (Figure 6.2) Go to the Advanced Learn display. It does

not matter whether you were in Iron Mask or Discrim

(shown in the adjacent figure).

STEP 2 (Figure 6.3) Press the shift button next to Reject All/

Accept All icon to fill in the screen. The icon changes to

all clear to indicate that the next time it is pressed, the

Learn screen will clear. Press the button again to clear

the screen and accept all targets.

STEP 3 While the screen is completely cleared, rest the coil and

check for interference (erratic noises and random

movements of the target crosshair). If you experience

interference press Noise Cancel, reduce the Sensitivity,

or move the detector to a different place.

STEP 4 Check the area of ground where you would like to learn

the target to make sure that there are no other targets in

the ground.

STEP 5 Press the Reject All/Accept All shift button to completely

fill the screen and reject all targets.

STEP 6 (Figure 6.4) Press the lower left hand shift button twice to

change the cursor to medium size. The size of the cursor

sets how ‘loosely’ the target is matched for each

successive pass of the coil. Place the target on the

ground and press the upper left shift button next to the

Accept icon. The tick will begin to flash.

Now the detector is prepared to Learn targets.

tutorial

LEARN’S TARGET SELECTION

Figure 6.4 Reject all fills the screen

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 111 112

No comments

Minelab EXPLORER II Service Manual Page 77