Minelab F3 Service Manual download pdf (Page 14)

F3 Field Service Manual

Page 14

1 8007-0023 UPPER SHAFT BLACK F3

2 9511-0097 WIRING LOOM F3 SHAFT/HANDLE

3 COIL CABLE (PART OF 2021-0054 COIL F3)

4 8009-0007 RETAINER PLUG F3

5 COIL PLUG (PART OF 2021-0054 COIL F3)

6 3004-0036 ELECTRONICS PACK KIT SVC F3L

6 3004-0001 ELECTRONICS PACK KIT SVC F3

7 4003-0101 SCREW M3x20 SKT CAP

8 4309-0039 O-RING BULKHEAD 50MM

9 0703-0095 COVER BULKHEAD F3

10 4003-0084 SCREW NO 3X16 POSI SS

11 4003-0084 SCREW NO 3X16 POSI SS

12 4309-0044 GROMMET BULKHEAD F3

13 0703-0097 COVER RIBBON CABLE F3

Figure 10: Electronics Pack

NOTE

The F3L electronics pack can be identified by a yellow dot on the rear of the housing.

a. To remove the electronics pack:

● Remove battery pack and sensitivity endcap.

● Undo and remove the six screws (Part 10) holding the bulkhead cover (Part 9) to the

electronics pack rear panel.

● Pull the bulkhead cover away from the electronics pack.

● Gently unplug the wiring loom plug from the electronics pack printed circuit board.

(Figure 11)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

No comments

Minelab F3 Service Manual Page 14