Minelab F3 Service Manual download pdf (Page 35)

F3 Field Service Manual

Page 35

Figure 48: Upper Camlock Positioned on Upper Shaft

● Place the tail of the upper pressure block into the recess in the rear of the upper

camlock body and push the block down into the square hole. (Figure 49)

NOTE

Ensure that the pressure block does not protrude too far into the shaft. If necessary push it

back into the camlock body otherwise difficulty may be encountered when fitting the middle

shaft.

Figure 49: Reassembling the Upper Camlock Assembly

● Hold the cam lever in place whilst the cam lever pivot pin is pushed into the camlock

body.

● Open the upper cam lever.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 41 42

No comments

Minelab F3 Service Manual Page 35