Minelab F3 Service Manual download pdf (Page 24)

F3 Field Service Manual

Page 24

● Refit the three (or five depending on speaker pod version) screws (Part 5) which hold

the pod halves together.

● Refit sensitivity endcap and battery pack.

3.6 Handle. Figure 30 illustrates the major parts of the handle.

8013-0001 HANDLE ASSEMBLY F3

1 4002-0023 NUT M4 NYLOC SS

2 3004-0016

RIGHT HANDLE HALF (part of HANDLE L+R

KIT F3)

3 3004-0016

LEFT HANDLE HALF (part of HANDLE L+R KIT

F3)

4 4002-0038 NUT STANDARD SS F3

5 4309-0037 DUSTCAP EARSET F3

6 8301-0031 SWITCH ASSY SLIDER F3

7 9511-0097 WIRING LOOM F3 SHAFT/HANDLE

8 4003-0062 BOLT M4X20 SKT SS

9 4003-0061 BOLT M4X10 SKT SS

Figure 30: Exploded View of Handle

NOTE

The noise cancel button and earset connector are an integral part of the main wiring loom

and this assembly is waterproof. Do not try to disassemble the main wiring loom. It is not

repairable.

a. To disassemble the handle:

● Remove the speaker pod (Section 3.5.a).

● Undo and remove the four nuts and bolts holding the handle halves together.

● Carefully separate the left handle half from the upper shaft.

● Remove the nut (Part 4) that secures the lower speaker pod screw to the handle.

● Remove the earset dustcap. (Part 5).

● The wiring loom (Part 7) and on/off switch assembly slider (Part 6) can now be

removed from the right handle half if required.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 41 42

No comments

Minelab F3 Service Manual Page 24