Minelab F3 Service Manual download pdf (Page 18)

F3 Field Service Manual

Page 18

Figure 16: Removing the Coil Retainer

● Lift the lower shaft with lower camlock assembly out of the coil top.

● Carefully pull the coil cable out from inside the shafts.

● If necessary, remove the coil pin for use with the replacement coil.

NOTE

If there is any damage to the coil or coil cable, the coil must be replaced. There are no

repairable parts on the coil.

b. To fit a new coil:

● Ensure a skid plate is fitted to the coil.

● If necessary connect a coil pin by: (Figure 17)

- inserting the coil pin into the top spirals of the coil cable

- positioning the coil pin so that the straight portion of cable is aligned with the

channel in the coil pin

- pressing the coil pin onto the coil cable, so that it is firmly held in position

Figure 17: Inserting the Coil Pin

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 41 42

No comments

Minelab F3 Service Manual Page 18